Embedded Files
Directions:
Directions:
Step 1:
Remove Pikachu and the ball from the set base and place to the side. Place the 4x4 brick tops on the underside of the set base.
Step 2: Connect the arms exactly as shown in the picture below in the exact location shown. Short on the right, long on the left. Ensure they are straight and semi level as if you were getting ready to screw them to the wall. Dont tighten them all the way, they should still piviot on the ball. This will help with alignment on the wall later.
Step 3: Hold the set against the wall ensuring the set base is level and the base of the arms are flat against the wall. You may need to loosen/tighten slightly the brick tops to adjust the arms into the correct position and get the set base level. I recommend having someone help you now. Using your other hand, mark the holes or ask someone for help to do so. The short arm on the right, will be higher than the long arm on the left.
Step 4: Unscrew the brick tops from the arms, leave them attached to the set in the correct locations and secure the arms to the wall using the included screws/anchors (if requested). Place optional cover over arm base. The short arm on the right, will and should be higher than the long arm on the left.
Step 5: Place the set back on the arms making sure to line up the balls with the arms, ensure the set base is level and tighten the balls securly. You can now place the set back on the set base.
Step 6: Done!
Have a question? Have a problem? Please reach out!
[ bp3dprintshop@gmail.com] [ 509 - 866 - 6195 ]
Please don't forget to leave a REVIEW! I LOVE seeing your Lego collections and how you use the stands!
Please post a photo review!
Page updated
Google Sites
Report abuse